Eigenschaften
- Suitable for use on slightly (matt) moist, cement-based substrates.
- Good chemical resistant
- Water vapour permeable - suitable for unsealed floor plates with contact to the ground, and for magnesite- and anhydrite screeds
- Variable use as primer, scratch-filler, self-levelling fluid coating or layer mixed and scattered with quartz sand
- Anti-slip, safe surfaces can be achieved
- Emission-minimimised and tested for harmful substances by Technical Control Board (TÜV)
Verbrauch
Priming coat Brush application Disbopox 453 Verlaufschicht, diluted material | approx. 500–800 g/m2 |
Scratch filler application Disbopox 453 Verlaufschicht Disboxid 942 Mischquarz | approx. 1,040–1,200 g/mm/m2 approx. 210–240 g/mm/m2 |
Repair mortar Disbopox 453 Verlaufschicht Disboxid 946 Mörtelquarz | approx. 300 g/mm/m2 |
Self-levelling coating (smooth)✱ Min. 2 mm, max. 5 mm wet layer thickness (min. 8 mm V-notched tool)✱✱ | |
Disbopox 453 Verlaufschicht | approx. 1,750–2,000 g/mm/m2 |
Anti-slip coating (mixed & scattered with quartz sand) | |
Mixed material Disbopox 453 Verlaufschicht Disboxid 942 Mischquarz Covering with sand Disboxid 943/944 Einstreuquarz Finishing sealing coat✱✱ Disbopox 442 GaragenSiegel Disbopox 447 Wasserepoxid | approx. 3.0 kg/m2 approx. 600 g/m2 approx. 3–4 kg/m2 |
✱ Consumption must not fall below 3.5 kg/m2 to avoid failures of the levelling properties.
✱✱ Size of V-notch depends on abrasion resistance of scrapers, temperature, filling degree, and substrate conditions. The consumption of the finishing sealing on sprinkled coatings varies depending on temperatures, way of application, tools and different substrate materials. All values are recommondations. The exact rate of consumption has to be determined by a trial application on site.
Glanzgrad
Silk-matt
Farbe
Pebble Grey, Stone Grey, Medium Grey
Special tints are available on request.
Exclusive colour designing is possible by the use of FloorColor collection. Discolouration and chalking effects may occur with weathering and UV light exposure. The pigmentation in, e.g. coffee, red wine or leaves (organic dyestuffs) and various chemicals, e.g. disinfectants, acids, etc., may cause discolouration. Scratch-marks may appear on the surface due to continued rubbing/sliding. The functional capability of the coating will not be affected by these changes.
Note: Varying layer thickness and non-uniform drying may cause slight colour differences for intensively tinted material. |